-----Original Message----- From: Harald A.Eriksen <[email protected]> Sent: Saturday, June 05, 2010 10:23 AM To: [email protected] Subject: Re: [Repeater-Builder] Using IC-F1010 x 2 as repeaters???
Gareth Bennett Thank`s for your replay. Just what I was looking for. Since I have these two radios, and the old repeater is more than 20 years old I will make a try!! Regards Harald A.Eriksen la4vna Gareth Bennett skrev: > > You will need to utilise the OPC-617 interface leads. With these you > can configure the radios as a "Basic Repeater". > Just a simple process of bringing out the DB9 sockets from the OPC-617 > to a common mating block with a trimmer pot between the audio out and > mic in ports for setting up line levels and tying the "Busy Out" to > the "TX" line. > Just bear in mind that you are dealing with mobiles that exhibit > little selectivity and a very low TX duty cycle, so not the best > choice to deploy in RF dense locations and if you are planning to > utilise the repeater in a high duty cycle situation. > Cheers > Gareth Bennett > RadioSystems > P.O. Box 5202 > Dunedin 9024 > New Zealand > [email protected] <mailto:[email protected]> > > ----- Original Message ----- > *From:* Harald A.Eriksen <mailto:[email protected]> > *To:* [email protected] > <mailto:[email protected]> > *Sent:* Saturday, June 05, 2010 8:17 AM > *Subject:* [Repeater-Builder] Using IC-F1010 x 2 as repeaters??? > > hi. > Can our radiogrop use icom icf1010 as a repeater? Where can we get > info > and connection equitment? > Thanks and best regards > la4vna, Harald > > ------------------------------------ Yahoo! Groups Links [The entire original message is not included]
