Thanks Bill, But that control does nothing either.
This repeater was used with a Pacific Research controller before that has a squelch circuit built in. It did not come with a squelch card. I don't know where to look for the problem... Stan From: [email protected] Sent: Tuesday, July 06, 2010 9:31 AM To: [email protected] Subject: Re: [Repeater-Builder] MSR2000 The squelch gate card control tells the transmitter when to transmit. The squelch control on the R1 audio module gates the receiver squelch noise. Bill In a message dated 7/6/2010 8:01:31 A.M. Central Daylight Time, [email protected] writes: Yesterday I finally plugged this MSR2000 in with a dummy load on it. It came on with an open squelch and went right into transmit mode. The squelch control on the squelch gate card did not close the squelch. I cannot find any way to close the squelch. If I pull the squelch gate card out it quiets the squelch. I hope it is not a defective squelch gate card. Any thoughts? This is my first experience with the MSR2000. Thanks Stan, WA2UET
