I'm in the exact same boat working on a remote receiver. I don't want the link keyed 24-7 either. I now there are some voters out there that don't require 1950hz and some that don't need it present 100% of the time to keep that voter port active. But are there any other voters in the used or DIY market that's in the HAM budget. That do not require the 1950hz tone at all. Here one I found on RB but I will need eventually 3 ports. http://www.repeater-builder.com/rbtip/wb2whc.html Can one more port be added and has anyone had good success with this unit? Thanks All, Ross kc7rjk -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Tim - WD6AWP Sent: Sunday, July 25, 2010 3:19 PM To: [email protected] Subject: [Repeater-Builder] Recommendations for a Voter Link I'm going to start working on building a link for a remote receiver. I already have a voter and I'll be using a VHF Micor receiver strip for the remote.
A couple of mobiles that tune down to 420 might be good as I don't have a lot room. I'm thinking the link transmitter will be keyed 7x24 with tone signaling. However the duty cycle requirement is a problem for mobiles. A microwave system might be possible if I knew what and where to get. Wireline is probably out. I'd like to hear your ideas on how to put this together. Thanks, Tim P.S. Sorry if this post is a dup. The first one did seem to come through this morning.
