A Maxtrac would probalby do the job. It takes some work to get it down
below 146 MHz though. Check the Repeater Builder website for info.
73,
Mike
WM4B
On Sat, Aug 28, 2010 at 9:59 AM, vk4jrc wrote:
I am looking to build an APRS Digi on 2 metres. I had considered
using a Yaesu FT-1802 radio, but was concerned that the receiver may not
work very well on a community RF siite. My other radio of choice could
be the Vertex VX-2200 commercial model? Only problem is the audio level
requirement via the 15 pin accessory port, for 1200 baud, may need some
amplification.
Any other suggestions for a better solution? Ideas for any models with a
high spec receiver? Location/URL for secondhand units?
Any ideas appreciated.
73,
Jack VK4JRC
<http://docs.yahoo.com/info/terms/>
