If that is true, then you probable need to used a compressed rbf. I imagine you are using an uncompressed one now.
-dalon On Thu, Jun 22, 2017 at 11:59 AM, Janet Estabridis <jpe1...@mchsi.com> wrote: > Well it booted with the GSRD just fine so I didn't figure I needed to > change anything, right? > I will look now and get back to you. > Janet > > ------------------------------ > *From: *"Dalon Westergreen" <dwest...@gmail.com> > *To: *"Janet Estabridis" <jpe1...@mchsi.com>, "rfi" < > rfi@lists.rocketboards.org> > *Sent: *Thursday, June 22, 2017 11:56:49 AM > *Subject: *Re: [Rfi] u-boot error on Macnica Sodia --> soc_system.rbf > altera load: Failed with error code -4 > > > What is the FPGA configuration set to? MSEL pins? It needs to be set to > FPP. > > --dalon > > On Thu, 2017-06-22 at 14:48 -0400, Janet Estabridis wrote: > > Thanks in advance. > > So, I've had trouble getting the Sodia to work with the fpga2hps with Quartur > 15.1. > > I saw the link below and it explains that U-boot 2013.01.01 solves this and > I found that the GSRD 16.1 for the Sodia has this U-boot. > https://rocketboards.org/foswiki/view/Documentation/GSRD160ProgrammingFPGAfromHPSArrowSoCKitEdition#GSRD_FPGA_Configuration > > So, we took the GSRD and added our IP that uses the fpga2hps bridge. Did all > the Quartus stuff necessary, got a .sof generated a .dtb file and an .rbf (I > wasn't sure what .rbf format to use so I have tried them all - same error). > > I am enclosing the minicom output from the boot. Basically it reads the > .rbf file but then gives me "altera load: Failed with error code -4. > I haven't been able to find out what that means... been Googling... > > Any insight would be greatly appreciated. > > _______________________________________________ > Rfi mailing > listRfi@lists.rocketboards.orghttp://lists.rocketboards.org/cgi-bin/mailman/listinfo/rfi > > >
_______________________________________________ Rfi mailing list Rfi@lists.rocketboards.org http://lists.rocketboards.org/cgi-bin/mailman/listinfo/rfi
