The only time I’ve ever seen RDAirplay race through the logs is when it runs out of audio channels, but it indicates that fact in the logs. This happened when our ASI card was set to 4 channels instead of 12.
Patrick > On May 17, 2019, at 5:37 PM, Brian P. McGlynn > <[email protected]> wrote: > > I see the same behaviour on RC2. I have to restart the daemons to get it to > work. > > I looked through the logs, and nothing was obvious. > > Sent from my iPad > > On May 17, 2019, at 10:06, Tom Van Gorkom <[email protected] > <mailto:[email protected]>> wrote: > >> Using Riv 3.0 with CentOS 7 with the Livewire driver on a standalone for >> both testing and a backup audio source if the automation goes quiet... >> >> Running a series of about 20 logs in a loop, RDairplay runs fine for about 3 >> days at a time and then starts scrolling rapidly through each log. I have to >> force quit RDairplay and restart it again. I re-generated all of the logs to >> make sure there were no issues with them and started in different places >> with the same result. The same setup with Riv 2.19 and CentOS 6 on identical >> hardware works flawlessly. What might be causing this? >> >> Tom Van Gorkom >> Radio Esperanza Engineering, KRIO AM/FM, KOIR FM >> Office: 956-380-8150 >> Cell: 865-803-7427 >> >> Rio Grande Bible Institute >> 4300 S US Hwy 281 >> Edinburg, TX 78539 >> _______________________________________________ >> Rivendell-dev mailing list >> [email protected] >> <mailto:[email protected]> >> http://caspian.paravelsystems.com/mailman/listinfo/rivendell-dev >> <http://caspian.paravelsystems.com/mailman/listinfo/rivendell-dev> > _______________________________________________ > Rivendell-dev mailing list > [email protected] > http://caspian.paravelsystems.com/mailman/listinfo/rivendell-dev
_______________________________________________ Rivendell-dev mailing list [email protected] http://caspian.paravelsystems.com/mailman/listinfo/rivendell-dev
