I just set up rl for the first time. I have a USR 56k modem and rl didn't recognize 
it. I'm very
impressed with rl otherwise! I'm not too familiar with linux so I'm pleased setup is 
so simple and
operation is very very quick compared to Msoft stuff, but I don't know how to approach 
the modem not
working...

Lee

----- Original Message -----
From: "Fred Schuchart" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Sunday, October 14, 2001 7:03 PM
Subject: [rl-users] US Robotics 56K Int PnP Modem


I installed Build 40, RC1 and everything went fine.  The only problem was
that the installation didn't set up my US Robotics PnP Modem - even though
I had the PnP turned off in the Bios.  This was the first time this has
happened - I was always surprised with RL because it did install it
correctly in the past builds.  This was the only Linux distribution that I
found that would do it right from the installation - and it spoiled me.

Subsequently I have tried getting it working with isapnp and setserial and
am having a hard time getting it to work.  Anyone have similar problems,
and been able to get the modem working.

Joseph - any suggestions?

Fred

-
--
rl-users list.  To leave, send "unsubscribe" without quotes in body of
message to [EMAIL PROTECTED]
Archive: http://www.mail-archive.com/rl-users@chicago.redmondlinux.org/

-
--
rl-users list.  To leave, send "unsubscribe" without quotes in body of
message to [EMAIL PROTECTED]
Archive: http://www.mail-archive.com/rl-users@chicago.redmondlinux.org/

Reply via email to