Salut
Simt ca innebunesc. Am un sistem cu o placa de retea onboard (via rhine)
si una pe pci (3c905b).
La reboot, placa 3com dispare. Adica:
[EMAIL PROTECTED] ~]# lspci | grep Eth
00:0a.0 Ethernet controller: 3Com Corporation 3c905B 100BaseTX [Cyclone]
(rev 30)
00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II]
(rev 74)
[EMAIL PROTECTED] ~]# dmesg | grep 3c
3c59x: Donald Becker and others.
0000:00:0a.0: 3Com PCI 3c905B Cyclone 100baseTx at e08b6f80.
[EMAIL PROTECTED] ~]# dmesg | grep eth
eth1: VIA Rhine II at 0xdffffd00, 00:0b:6a:6c:95:6e, IRQ 18.
eth1: MII PHY found at address 1, status 0x7869 advertising 05e1 Link
41e1.
eth1: link up, 100Mbps, full-duplex, lpa 0x41E1
eth1: no IPv6 routers present
Despre eth0, nimic. Alte chestii pe care le-am facut:
[EMAIL PROTECTED] ~]# ifup eth0
3c59x device eth0 does not seem to be present, delaying initialization.
[EMAIL PROTECTED] ~]# cat /etc/modprobe.conf | grep eth
alias eth0 3c59x
alias eth1 via-rhine
[EMAIL PROTECTED] ~]# cat /etc/udev/rules.d/010_netinterfaces.rules
KERNEL=="eth*", SYSFS{address}=="00:01:02:AE:6C:37", NAME="eth0"
KERNEL=="eth*", SYSFS{address}=="00:03:47:D6:6B:D2", NAME="eth1"
Macurile sint puse si in ifcfg-eth*.
Ei bine, totul are loc aleator. Daca rebootez de citeva ori, apare si
eth0. Citeodata e nevoie sa scot si cablul de alimentare pentru citeva
minute, dar in final tot apare.
Wtf ?! Cum fac sa am eth0 si eth1 corect si de fiecare data ?
Multumesc
----
- Where is Spiderman ?
- He quit.
_______________________________________________
RLUG mailing list
[email protected]
http://lists.lug.ro/mailman/listinfo/rlug
