Hi All,
With all the comments about working with brass, I have a question. The cab on
my
OMI SW1500 brass switcher came apart from the hood while I was installing a
sound system. The separation occurred at the point where the two pieces were
soldered before. Can the two pieces be soldered together using a soldering
iron?
I don't have a resistance soldering system (too expensive) or a torch. I've
tried to solder some brass before with little or no success. The solder beaded
up and didn't flow. Any advice will be appreciated.
Ed Davis
Stockton
[Non-text portions of this message have been removed]
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/S-Scale/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/S-Scale/join
(Yahoo! ID required)
<*> To change settings via email:
[email protected]
[email protected]
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
