I have a couple of custom TOs from Tomalco. Once I find out how to measure the arc, I can check them out.
Of course I have to remember what radii they are. Ken On Fri, Jun 15, 2012 at 1:23 PM, Jonnyspeed <[email protected]> wrote: > Hi John, > > I'm not sure what you mean? I would like to know what the arcs are in > degrees for the #6 curved turnout assembly. > > Thanks, > Jonathan > > --- In [email protected], rxman46321@... wrote: > > > > If you asked, all thier products are available in any scale. There is a > > reasonable charge to set it up but then it goes into stock and is > available > > for all. They did a custom 44 inch, 40 inch and a 36 inch curve template > for > > me that was not "available". > > > > John Griffin > > Des Plaines Valley > > > > > > >
