If I read this right.... I have a trio of broad curved turnouts. I forget what I ordered but the inside curve (the mainline) would have been a minimum of about 44 inches.
Three of them make a 90 degree turn so one is therefore a 30 degree arc. Does that sound reasonable? Ken On Fri, Jun 15, 2012 at 1:48 PM, ken garber <[email protected]> wrote: > I have a couple of custom TOs from Tomalco. Once I find out how to > measure the arc, I can check them out. > > Of course I have to remember what radii they are. > > Ken > On Fri, Jun 15, 2012 at 1:23 PM, Jonnyspeed <[email protected]> wrote: > >> Hi John, >> >> I'm not sure what you mean? I would like to know what the arcs are in >> degrees for the #6 curved turnout assembly. >> >> Thanks, >> Jonathan >> >> --- In [email protected], rxman46321@... wrote: >> > >> > If you asked, all thier products are available in any scale. There is a >> > reasonable charge to set it up but then it goes into stock and is >> available >> > for all. They did a custom 44 inch, 40 inch and a 36 inch curve >> template for >> > me that was not "available". >> > >> > John Griffin >> > Des Plaines Valley >> > >> >> >> >> >>
