RE: [SA-list] Execute command

[Jason Passow]

hursday, June 12, 2003 7:58:52 AM GetServiceStatus salive: Running Thursday, June 12, 2003 7:58:52 AM NTService check of salive on 192.168.1.10 OK Thursday, June 12, 2003 7:58:53 AM GetServiceStatus winvnc: Stopped Thursday, June 12, 2003 7:58:53 AM NTService check of winvnc on 192.168.1.10 failed Thursday, June 12, 2003 7:58:53 AM GetServiceStatus W3SVC: Running Thursday, June 12, 2003 7:58:53 AM NTService check of W3SVC on 192.168.1.10 OK   No error in the log.   I do not know if it should show executing the command but it does not.   -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Dirk Bulinckx Sent: Wednesday, June 11, 2003 4:22 PM To: [EMAIL PROTECTED] Subject: RE: [SA-list] Execute command   Make sure to enable debug logging and then check in the logfile for the error (if any)   Dirk. Woodstone is moving it's offices to a new location. Response to email will be delayed due to this. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]On Behalf Of Jason Passow Sent: Wednesday, June 11, 2003 10:14 PM To: [EMAIL PROTECTED] Subject: [SA-list] Execute command I have a couple issues.  I am monitoring a vnc service on our server.  Occasionally it crashes and I am locked out so I monitor it to be sure it gets restarted.  The check works fine but when it is down it does not seem to restart the service like it should.  I also created an external program that restarts the service.   I use it when Salive fails.  However it does not work from Salive either.  Any ideas?  Where can I find a log that might tell me what is going on?   Jason Passow [EMAIL PROTECTED] PO BOX 1036 5150 West Sixth St Winona, MN 55987