Good guess, but alas the Remote dial in unit is old and is set manually with no communications interface. I'll try doing something with HyperTerminal.
Thanks Barry -----Original Message----- From: Dirk Bulinckx [mailto:[EMAIL PROTECTED] Sent: July 28, 2003 11:48 AM To: [EMAIL PROTECTED] Subject: RE: [SA-list] Setting up SA with Remote Control Dialler I would guess that most vendors of this kind of devices have a command line tool for it.... Dirk. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Barry George Sent: Monday, July 28, 2003 4:15 PM To: Salive List Subject: [SA-list] Setting up SA with Remote Control Dialler Hi All, Need some ideas here if I may. We have a hardware Firewall that's now in the habit of locking up regularly requiring a reboot to bring back up. We've placed a remote power on/off controller in the line of the firewall so we can dial in, send a code and turn off/on the power. I need to SA to dial out on its internal modem, wait for an answer, send the assess code, wait then send the code to turn off the power. I'd like to automate this with SA, but I'm not sure of the best route. Scripting I guess is one possibility? Anyone recommend any software to use as an external check in this case? Thanks Barry To unsubscribe from a list, send a mail message to [EMAIL PROTECTED] With the following in the body of the message: unsubscribe SAlive To unsubscribe from a list, send a mail message to [EMAIL PROTECTED] With the following in the body of the message: unsubscribe SAlive To unsubscribe from a list, send a mail message to [EMAIL PROTECTED] With the following in the body of the message: unsubscribe SAlive
