I do not fully understand your question but if the cable ip is down and you want after an hour or so to make it come back up (by way of a batch file) you can set an alert to execute the batch after 12 times (depending on your time between checks) down. Does this answer your question?
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of gene Martinez Sent: Tuesday, September 30, 2003 10:13 AM To: [EMAIL PROTECTED] Subject: RE: [SA-list] different versions of Salive I'm a registered user of Salive version 3. (I know I need to upgrade, will soon). I have it running on a 2000 server. So far so good. Can I install version 4 (in a different directory) along with version 3, or do I have to uninstall version 3 first?? Also I have a dial-up account & cable account. On I pc I have (2) nics. What I do is when the pc boots it does a release/renew, so it's connected to the cable. When I need to use the dial-up, I have a batch file that will switch from cable ip to modem ip address. I also have (1) to switch the other way. What I was wondering is??? I only use the dial-up for a 1/2 hour or so. Can I have Salive check (ping) the cable ip, it's always the same, and then an hour from the time that it failed (as I'm not on dial-up that long) have Salive run a batch file that will switch it back to cable? Thanks Regards, Gene [EMAIL PROTECTED] http://www.eclipse.net/~njkat To unsubscribe from a list, send a mail message to [EMAIL PROTECTED] With the following in the body of the message: unsubscribe SAlive To unsubscribe from a list, send a mail message to [EMAIL PROTECTED] With the following in the body of the message: unsubscribe SAlive
