Hello, I am having enormous difficulty in getting samba to work correctly on the local network when the local network is on eth1.
I have never had any trouble with samba when I used eth0... Here is my routing table... Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 255.255.255.255 * 255.255.255.255 UH 0 0 0 eth1 192.168.1.0 * 255.255.255.0 U 0 0 0 eth1 192.168.0.0 * 255.255.255.0 U 0 0 0 eth0 default 192.168.0.1 0.0.0.0 UG 1 0 0 eth0 This same computer works perfectly in every other area. eth0 is dedicated to the internet and masq's the network. findsmb can only see the local computer. I do not have an interfaces line in my smb.conf, and adding it apparently makes little difference. eg, without the line, it apparently defaults to eth0 With the line interfaces = eth1, the ip of the local computer changes, to the ip that eth1 uses, however, findsmb can still only see the local computer. The other computers on the network can't see this local... Any suggestions? I have recently subscribed, but since I haven't recieved any messages for the past 24 hours, I do not know if I subscribed correctly, hence, could you please 'cc' me? I do not mind having several copies of a reply... Thanks in advance! -- To unsubscribe from this list go to the following URL and read the instructions: http://lists.samba.org/mailman/listinfo/samba
