Hello Andrew, Thanks for the quick answer, I tried with the commands you advised, but no success. The same message, command/directory not found. (the directory you mentioned, is empty. ) instead of this folder was found * /usr/local/samba/sbin*# I have added libraries to PATH also.
What can be the problem? A previously installed Samba? I have noticed, that smbclient cannot run also, it says cannot load smb.conf (the provision was successful previously) Shall I investigate in the log files of compilation or installation? Or make a clean install of whole server? Thanks in advance, Peter 2011. február 27. 21:51 Andrew Bartlett írta, <abart...@samba.org>: > On Sun, 2011-02-27 at 11:34 +0100, Santiago DIEZ wrote: > > Hi Peter, > > > > If the install worked fine, then you should be able to run the daemon > with: > > /usr/local/samba/smbd -- -D > > You probably can't call it without the full path because > > /usr/local/samba/is not in your path. > > > > If you want to remove a program compiled from source, go back to the > source > > directory and run > > make uninstallbin > > make uninstalldat > > make uninstallman > > make uninstallmo > > make uninstallmsg > > make uninstallscripts > > make uninstall > > The uninstall commands are not part of Samba4. > > As is almost correctly mentioned above, to run 'samba' (the Samba4 > server binary) from /usr/local/samba, you need to run: > > /usr/local/sbin/samba > > Andrew Bartlett > > -- > Andrew Bartlett http://samba.org/~abartlet/ > Authentication Developer, Samba Team http://samba.org > Samba Developer, Cisco Inc. > > -- Herczeg Péter -- To unsubscribe from this list go to the following URL and read the instructions: https://lists.samba.org/mailman/options/samba