Hi All: I hope You people will have time to help a relative novice with configuration of an HP 6100 C which is to be used intermidently on 2 different RH 7.3 systems.
As stated previously the scanner is an HP 6100C if I issue the command: The scanner is connected by 40 pin scsi. Several commands were issues with the following results: $ scanimage --list devices sg0 HP C2520A 36644 sg1 Mitsumi CD-R sg2 Soney CD-RW $ cat /proc/scsi/scsa Attached devices: Host: scsi0 Channel: 00 Id: 04 Lun: 00 Vendor: HP Model: C2520A Rev: 3644 Type: Processor ANSI SCSI revision: 02 Host: scsi1 Channel: 00 Id: 00 Lun: 00 Vendor: MITSUMI Model: CD-ROM FX4830T!B Rev: R02C Type: CD-ROM ANSI SCSI revision: 02 Host: scsi1 Channel: 00 Id: 01 Lun: 00 Vendor: SONY Model: CD-RW CRX175E2 Rev: S002 Type: CD-ROM ANSI SCSI revision: 02 $ export SANE_DEBUGG_HP=17 $ scanimage -L [scanei_debug] Setting debug level of hp to 17 [hp] sane_init called[hp] [hp] sane_init will finish with Success [hp] sane_get_devices called [hp] hp_read_config: hp backend v0.95 start reading conf file [hp] hp_read_config: processing line <scsi HP> [hp] hp_read_config: processing line </dev/scaner> [hp] hp_read_config: attach scsi HP [hp] hp_read_config: attach /dev/scanner [hp] hp_get_dev: New device /dev/scanner, connect-scsi, scsi-request=1 [hp] sanei_hp_device_new: /dev/scanner [hp] scsi_newopen failed (Invalid argument) [hp] /dev/scanner: Can't open scsi device [hp] sane_get_devices will finish with Success [hp] sane_exit called [hp] sane_exit will finish The sane configuration file /etc/sane.d/ho.conf is as follows: scsi HP /dev/scannet I would appreciate any advice you people may be able to offer. Thanks Frank Thanks
