On Sunday 16 October 2005 08:05, Jim MacLeod wrote: > Olaf Meeuwissen wrote: > > There's a good chance that the %post script was not converted so a > > number of post-install activities may not have been carried out. > > Iscan rpm version has been purged > > >> Files have installed in expected places - /usr/lib, /usr/lib/iscan etc > >> and the program runs, but only to advise "Could not send command to > >> scanner. Check status" > > > > Have you added the epkowa backend to /etc/sane.d/dll.conf? > > Yes - in fact this and snapscan are the only two enabled > > > What architecture are you using? It'll only work on IA32 (32bit ix86). > > Sempron 2600 so presume I'm ok. > > > Does sane-find-scanner list the device? > > Yes... > Compiled your sane-backend-25-10-11 (first time I've compiled anything) and > scanimage works ok. I scanned a page (without setting any parameters), but > I really want to get the transparency unit working. > Xsane or Kooka (kde) both fail with"no device found" and nowhere obvious to > change configuration so I'm stuck with no gui at the moment. > > >> However, has anyone got iscan working on a debian system or can offer > >> any pointers. Relative newbie, so easy on the technical stuff. > > Downloaded source.tar for iscan-1.17 but it fails at configure stage > advising 'imlibgdk and gtk-config not found'. I haven't been able to find > them either in Kubuntu repositories, particularly imlibgdk. > > > Works fine for me ;-) All iscan development (even my hacking at home) > > is done on Debian GNU/Linux testing machines. > > <Trying not to sound envious> Any pointers to reading material,howto's etc > gratefully received > > > Hope this helps, > > Jim Just saw this message. I'm having simular problems with my CX6600 All-in-one scanner on SuSE 10.0. It worked on 9.1. I tried the iscan 1.15 supplied with 10.0 and the 1.17.0-c2 from the webpage. Neither works.
sane-find-scanner reports: found USB scanner (vendor=0x04b8 [EPSON], product=0x0813 [USB2.0 MFP]) at libusb:001:003 # Your USB scanner was (probably) detected. It may or may not be supported by # SANE. Try scanimage -L and read the backend's manpage. I tryed changes in dll.conf and sane.d no help. I also noticed the iscan.usermap shows the product ID as 0x0805. 813 is what worked in 9.1. Have you any solutions on how ti get this working?
