Hi Rolf, I did a fresh install from GIT again and the scanning does work. I did find an issue: scanning over ethernet (bjnp://) works fine but over USB doesn't. This is the debug output when I select the USB connection:
$ xsane [sanei_debug] Setting debug level of pixma to 3. [pixma] pixma is compiled without pthread support. [pixma] pixma version 0.17.2 [pixma] pixma_collect_devices() found Canon PIXMA MG6300 at libusb:001:007 [pixma] Scanner model found: Name MG6300(Canon PIXMA MG6300) matches MG6300 series [pixma] pixma_collect_devices() found Canon PIXMA MG6300 at bjnp://canon-printer.x.x:8612 [pixma] pixma_find_scanners() found 2 devices [pixma] pixma_collect_devices() found Canon PIXMA MG6300 at libusb:001:007 [pixma] Scanner model found: Name MG6300(Canon PIXMA MG6300) matches MG6300 series [pixma] pixma_collect_devices() found Canon PIXMA MG6300 at bjnp://canon-printer.x.x:8612 [pixma] pixma_open(): Canon PIXMA MG6300 [pixma] Sending time: '13/03/17 10:45' [pixma] No response yet. Timed out in 8 sec. [pixma] No response yet. Timed out in 7 sec. [pixma] No response yet. Timed out in 6 sec. [pixma] No response yet. Timed out in 5 sec. [pixma] No response yet. Timed out in 4 sec. [pixma] No response yet. Timed out in 3 sec. [pixma] No response yet. Timed out in 2 sec. [pixma] No response yet. Timed out in 1 sec. [pixma] WARNING: Error in response phase. cmd:eb80 [pixma] If the scanner hangs, reset it and/or unplug the USB cable. I'll be doing some more debugging on this later today. BTW: printing over USB works fine; it? apparently not the USB stack that gives issues. -- Kind regards, Theo van Rijn
