Hi Theo, Maybe you need to disconnect your device from ethernet before you can scan at usb.
Cheers, Rolf Am 17.03.2013 11:02, schrieb Theo: > Hi Rolf, > > I did a fresh install from GIT again and the scanning does work. I did > find an issue: scanning over ethernet (bjnp://) works fine but over USB > doesn't. This is the debug output when I select the USB connection: > > $ xsane > [sanei_debug] Setting debug level of pixma to 3. > [pixma] pixma is compiled without pthread support. > [pixma] pixma version 0.17.2 > [pixma] pixma_collect_devices() found Canon PIXMA MG6300 at libusb:001:007 > [pixma] Scanner model found: Name MG6300(Canon PIXMA MG6300) matches > MG6300 series > [pixma] pixma_collect_devices() found Canon PIXMA MG6300 at > bjnp://canon-printer.x.x:8612 > [pixma] pixma_find_scanners() found 2 devices > [pixma] pixma_collect_devices() found Canon PIXMA MG6300 at libusb:001:007 > [pixma] Scanner model found: Name MG6300(Canon PIXMA MG6300) matches > MG6300 series > [pixma] pixma_collect_devices() found Canon PIXMA MG6300 at > bjnp://canon-printer.x.x:8612 > [pixma] pixma_open(): Canon PIXMA MG6300 > [pixma] Sending time: '13/03/17 10:45' > [pixma] No response yet. Timed out in 8 sec. > [pixma] No response yet. Timed out in 7 sec. > [pixma] No response yet. Timed out in 6 sec. > [pixma] No response yet. Timed out in 5 sec. > [pixma] No response yet. Timed out in 4 sec. > [pixma] No response yet. Timed out in 3 sec. > [pixma] No response yet. Timed out in 2 sec. > [pixma] No response yet. Timed out in 1 sec. > [pixma] WARNING: Error in response phase. cmd:eb80 > [pixma] If the scanner hangs, reset it and/or unplug the USB cable. > > > I'll be doing some more debugging on this later today. > > BTW: printing over USB works fine; it? apparently not the USB stack that > gives issues. >
