"Vorsprach, Bernd" <[EMAIL PROTECTED]> schrieb am 25.01.02: > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] > > > Subject: How to start the database with autosave on > > > > If you one time use the autosave_on command the DBMServer > will make this setting persistent until a autosave_off > command. > > Note that the database may switch autosave to off if there > are problems during an automatic log save. In this case > you will see error messages in the knldiag.err. > > Bernd
Although it might already be a bit late for a reply, I just found out that the database I currently use, does not switch on autosave either, when the appropriate service SAPDB: <dbname> (=> WNT 4) is stopped and started again (manual startup). Autosave is correctly switched on, when I shutted down the database instance and started it up again using the DBM. It is even switched on, when autosave has not been started during service start. I could not find any specific errors or messages in the knldiag or knldiag.err pointing to problems concerning autosave on. Any hints how to convince SAPDB to start with autosave on? (Kernel 7.3.0 Build 018-000-081-115') R�diger ________________________________________________________________ Keine verlorenen Lotto-Quittungen, keine vergessenen Gewinne mehr! Beim WEB.DE Lottoservice: http://tippen2.web.de/?x=13 _______________________________________________ sapdb.general mailing list [EMAIL PROTECTED] http://listserv.sap.com/mailman/listinfo/sapdb.general
