-- Martin Brunzema SAP AG (SAP DB Kernel)
> -----Original Message----- > From: Elias Martenson [mailto:[EMAIL PROTECTED]] > Sent: Montag, 2. Dezember 2002 22:32 > To: [EMAIL PROTECTED] > Subject: Re: 7.4 release - minor problems > > > [EMAIL PROTECTED] wrote: > > > - Looks like Database Manager on the 'View Details' page > shows only one log > > devspaces, while it sums up values for data devspaces. I > have two log > > devspaces (I've done screenshots if needed :-), 2* 10 GB, > but DM shows only > > 10GB. I cannot compare it to dbmcli results, because I > cannot figure out > > how to pull the usage percentages :-/ > > You might be using the DUAL log mode and thus mirroring the 10 GB log > over the two volumes. Check the LOG_MODE configuration parameter. I don't think so. Maybe you added the second log-volume and it is not activated yet. After adding an additional Log-Volume, the former Log must be written until the end. Only at this point it is possible to really add the volume. The time before the adding is "pending". You get infos about the LogVolume by the dbmcli-command info log regards, Martin -- Martin Brunzema SAP AG (SAP DB Kernel) _______________________________________________ sapdb.general mailing list [EMAIL PROTECTED] http://listserv.sap.com/mailman/listinfo/sapdb.general
