Grab your Phillips, it's... The Latest from The Screwdriver List!
When you flashed the BIOS, possibly it reset it to the defaults (other than recognizing your new hard drive) and it your boot options aren't set to FDD first. Change your boot options and you should be okay. Neal > Botteon wrote: > > Sorry if this is duplicate. Just found address for list. > > Good morning all. I have a P11 333, 128 MB RAM, Abit BH6, running > WinME that I built and been running for a long time. I bought a 40 GB > HD and it wouldn't get recognized, so flashed my bios w/out error > message and 40 GB recognized. However, couldn't get computer now to > boot to bootdisk. Pulled it and replaced 6 GB HD, reset bios to > recognize, and it wouldn't boot to bootdisk. Replaced floppy, same. > Floppy will read and write ok, so assume all is well there. Without > boot disk can't reflash old bios to see if that screwed me up, so I'm > up a creek, outside of running out and getting new MB. Any help? -- *-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-* Neal Pollack PressPlay Computer Consultants [EMAIL PROTECTED] http://www.pressplay.net Carbondale, CO, USA [EMAIL PROTECTED] "Only two things are infinite, the universe and human stupidity, and I'm not sure about the former." --Albert Einstein++++++++++++++++++++++++++++++++++++++++++++ That's all for now from The Screwdriver List "Red Stripe to Pin 1" ++++++++++++++++++++++++++++++++++++++++++++
