Hi Krishna,
you will not see Cos 5 in Threshold 1 because this is the default Threshold
for Cos 5. The running-config presents always only the non-default values,
e.g if you put an prefererence command on your dial-peers you will this
only as long as it is not the default value 0.
Regards
Steffen
2012/10/14 Krishna vinayak_...@yahoo.com
hi guys,
i was wondering whether i am doing right way of doing lan qos or not ??
the requirements are assign cos 5 to priority queue , cos 3 4 to queue 2
with 60% exceed of cos 4 should be dropped. so here is my configuration for
that
mls qos
mls qos srr-queue output cos-map queue 1 threshold 1 5
mls qos srr-queue output cos-map queue 2 threshold 2 3
mls qos srr-queue output cos-map queue 2 threshold 1 4
mls qos queue-set output 2 threshold 3 60 100 100 272
when i issued show run | i mls commands, i see every mls qos command
except the cos 5 which is assigned to q1 t1. Is my approach is correct in
dealing this question correctly?? does it matter whether we assign cos
values to t1 or t2 or t3 in the queues???
your input is much appreciated.
thank you
krishna.
___
For more information regarding industry leading CCIE Lab training, please
visit www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
___
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com