Re: [Elecraft] KPA3 removal

[Keith Trinity WE6R]

Hi Martin;
No need to remove the KPA3 to test the LPA, just set KPA3 to "not inSt" 
in the config menu.

Then you can go to 12W and go thru the bands and see how it does.
Also you can run the 5W TX gain cal using the K3 Utility (or TUNE at 
exactly 5.0W on all bands) to see what happens. The resulting "TXGN LP" 
numbers are typically below 60, higher numbers indicate something wrong, 
or you may get an ERR TXG. Go to config menu item "TXGN LP", then step 
thru the bands to see each one. Or just get the results using the K3 
Utility.


On the older LPAs like yours, R18 is for Q2, the _*D*_*_river._* It is a 
different device than the two finals, Q5 (R19) and Q4 (R24).
I believe the Bias increase is 300ma for each device, please contact 
support@elecraft for the procedure on this older LPA.

Keith WE6R

__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com

[Elecraft] KPA3 removal

[Martin Sole]

Hi,

I am about to start replacement of the LPA output devices. To do so I 
think I first need to remove the KPA3. Once done can I just operate the 
K3 at low power to prove the LPA? I don;t have the jumper block so would 
just leave the interface block in place. I'm assuming it does much the 
same thing at low power .


Is there a procedure of any sort I can follow?
What bias current should I set R18 and R19 for?

Thanks
Martin, HS0ZED

__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com