Re: [Repeater-Builder] Micor Station Conversion Problem
At 09:59 AM 04/29/07, you wrote: I have a Micor Station 100 VHF that was used as a paging base. I removed the backplane and installed a "normal" one and removed the cards for paging, and installed normal base station cards. I completed the conversion (removing diode) for allowing the receiver to operate all the time. Here is the problem...The receiver does not stay on when the PTT is pushed on the station control card. Is their a jumper I am missing somewhere? Close, it's a diode. Remove diode CR 957 from the receiver interconnect board. Yes, it's a PITA to get to. As long as you are there you will want to adjust any other jumpers that are on that board. Thanks, Jim, K8COP Mike WA6ILQ
RE: [Repeater-Builder] Micor Station Conversion Problem
Meter the pins to both the audio squelch board and reciever board and see where it is losing voltage while ptt is active (probably losing 9.6 volts somewhere) then find 9.6v supply and tie it in directly. You should have been able to use the paging backplane, I did on mine with outboard controller I just yanked all the cards but the station control module. tom n8ies "BIG BROTHER IS WATCHING YOU!" This message brought to you by the US Department of Homeland Security - Original Message - From: Jim, K8COP To: Repeater-Builder@yahoogroups.com Sent: 4/29/2007 1:06:30 PM Subject: [Repeater-Builder] Micor Station Conversion Problem I have a Micor Station 100 VHF that was used as a paging base. I removed the backplane and installed a "normal" one and removed the cards for paging, and installed normal base station cards. I completed the conversion (removing diode) for allowing the receiver to operate all the time. Here is the problem...The receiver does not stay on when the PTT is pushed on the station control card. Is their a jumper I am missing somewhere? Thanks, Jim, K8COP stime1177866390 Description: stime1177866390
[Repeater-Builder] Micor Station Conversion Problem
It's a Unified backplane. Jim, K8COP _,_._,___
[Repeater-Builder] Micor Station Conversion Problem
I have a Micor Station 100 VHF that was used as a paging base. I removed the backplane and installed a "normal" one and removed the cards for paging, and installed normal base station cards. I completed the conversion (removing diode) for allowing the receiver to operate all the time. Here is the problem...The receiver does not stay on when the PTT is pushed on the station control card. Is their a jumper I am missing somewhere? Thanks, Jim, K8COP