[Repeater-Builder] Re: PL BOARD
Don, I have a data sheet on the TS32 and can give info on installing it, but no particulars on the 13-509. Let me know your direct e-mail and I can send. Just a few basic notes you need for install: TS32 audio input, connect to discreminator audio...do not use speaker audio for it often does not have the low freq response for the tone. Out 1 and 2 are the logic outputs for decode...out 1 low for decode, out 2 high. Must have HANGUP grounded or will stay in decode continously. For encode connect to 13-509 encode input. Often the mike input does not have low freq response for tone, not always. Most FM rigs have a special input for the tone. Of course I am thinking this type of info on the 509 is what you are looking for. 73, ron, n9ee/r --- In Repeater-Builder@yahoogroups.com, Don [EMAIL PROTECTED] wrote: I am trying to Donate to a New Blind Ham, a old Cobra 200 Which is the same as the Midland 13-509 220 Mobile, The problem is I don't have the Schematic and I would like to put a Communications Specialist TS-32 Pl Board so he can get into My 220 repeater, I know it is a old radio but I am sure someone might have the info I need to install it. Please tell Me in Layman terms. Thanks Don KA9QJG
[Repeater-Builder] Re: PL Board level
--- In Repeater-Builder@yahoogroups.com, Dave VanHorn [EMAIL PROTECTED] wrote: I just picked up a little problem, my PL boards are dropping out sometimes when I have a valid PL. Can anyone tell me offhand what the PL signal voltage should be at the input to the boards? (TS-32 in this case) I have about 0.8Vpp, which I would have thought was enough. ComSpec's web site does not specify a level but the troubleshooting section in the instruction sheet for the TS-32 implies a 100 mV signal. Here is the link: http://www.com-spec.com/insheet/ts107.pdf Check the Decoder Input section on page 3 as well as the troubleshooting section on page 6. Scott Madison, WN1B Yahoo! Groups Links * To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ * To unsubscribe from this group, send an email to: [EMAIL PROTECTED] * Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
[Repeater-Builder] Re: PL Board level
ComSpec's web site does not specify a level but the troubleshooting section in the instruction sheet for the TS-32 implies a 100 mV signal. Here is the link: http://www.com-spec.com/insheet/ts107.pdf Thanks! I had the first part, but not the rest. I'll give it a shot. One thing I installed today, was a 2 channel rack mount scope, so that won't be hard at all :) Yahoo! Groups Links * To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ * To unsubscribe from this group, send an email to: [EMAIL PROTECTED] * Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/