Re: [Alsa-user] Kernel config for specific cards

Thanks. The board runs on Alsa 1.0.25 and a 3.4 kernel with the old endpoint streaming model, I'll try to bring it up with the current release. 2016-02-14 12:26 GMT+01:00 Clemens Ladisch : > I wrote: > > P Z wrote: > >> The distortion characteristics on arm changed

Re: [Alsa-user] Kernel config for specific cards

Thanks, appreciate that. I was thinking EEPROM, but I guess some cards also have RAM which has to be initialized on every power cycle. As far as x86 goes,I tried Ubuntu 10.10/1.0.23 and it worked like stated on the vendor matrix page, but only with a live disk - VM had stutter / was completely

Re: [Alsa-user] Kernel config for specific cards

P Z wrote: > The distortion characteristics on arm changed slightly, which points to a > firmware issue. I suspect that the DMA of the frequency feedback data is not handled correctly. I'll see if I can create a patch this weekend ... > why for certain cards there's firmware loaded - and why by

Re: [Alsa-user] Kernel config for specific cards

I installed the old windows EMUU_PCAppDrvFw_L6_1_30_07 which updates (in this case reverted to an older version) the firmware on the card. The distortion characteristics on arm changed slightly, which points to a firmware issue. Honestly, I'm a bit at a loss as to why for certain cards there's

Re: [Alsa-user] Kernel config for specific cards

Odd, the VU meter is animating, but no sound. A few times, aplay freezed after 1-2 seconds. Arecord also doesn't work. bla@ubuntu:~$ aplay -D plughw:1,0 Desktop/Jamiroquai44100-24.wav -V mono -v Playing WAVE 'Desktop/Jamiroquai44100-24.wav' : Signed 24 bit Little Endian in 3bytes, Rate 44100 Hz,

Re: [Alsa-user] Kernel config for specific cards

P Z wrote: > Trying to ddx on the sunxi side, judging from the test soundfile and > given the fact that recording works, how likely is it that this is > a power supply issue Pretty much impossible. > aplay -D plughw:1,0 /home/bla/Desktop/Jamiroquai44100-24.wav So what happens? It might be

Re: [Alsa-user] Kernel config for specific cards

Yes, see log. Trying to ddx on the sunxi side, judging from the test soundfile and given the fact that recording works, how likely is it that this is a power supply issue (I tried 2 adapters, no noticeable difference in distortion). bla@ubuntu:/proc/asound$ cat cards 0 [AudioPCI ]: ENS1371

Re: [Alsa-user] Kernel config for specific cards

P Z wrote: > No luck with that. I assume in VMware VM > Removable Devices > Emu 0202 > > Connect is direct USB passthrough. > After uninstalling the windows drivers the card doesn't show up in the > Ubuntu System Settings > Sound anymore > but can still be seen by lsusb. Does it show up in

Re: [Alsa-user] Kernel config for specific cards

No luck with that. I assume in VMware VM > Removable Devices > Emu 0202 > Connect is direct USB passthrough. After uninstalling the windows drivers the card doesn't show up in the Ubuntu System Settings > Sound anymore but can still be seen by lsusb. 2016-01-26 8:36 GMT+01:00 Clemens Ladisch

Re: [Alsa-user] Kernel config for specific cards

P Z wrote: > On my Ubuntu 14.4 VM Alsa works with the onboard SC. Unless routed > through the windows mixer, no sound though from the emu, it fails > silently. Did you uninstall the Emu Windows driver, and tell the VM to allow Linux to access the Emu USB device directly? Regards, Clemens

Re: [Alsa-user] Kernel config for specific cards

On my Ubuntu 14.4 VM Alsa works with the onboard SC. Unless routed through the windows mixer, no sound though from the emu, it fails silently. I also checked the alsamixer levels. 2016-01-25 9:38 GMT+01:00 Clemens Ladisch : > P Z wrote: > > recording and playback under

Re: [Alsa-user] Kernel config for specific cards

P Z wrote: > recording and playback under windows is fine. But Windows doesn't run on sunxi hardware, does it? Does it run with Linux on x86? Regards, Clemens -- Site24x7 APM Insight: Get Deep Visibility into

Re: [Alsa-user] Kernel config for specific cards

P Z wrote: > I have an E-mu 0202 with distorted playback under the default snd_usb_audio > module on a sunxi kernel. Does the 0202 work with other hardware? > According to the old instructions you have to specify --with-cards=emu10k1 > when configuring the driver. That is wrong. The emu10k1

[Alsa-user] Kernel config for specific cards

Hi, I have an E-mu 0202 with distorted playback under the default snd_usb_audio module on a sunxi kernel. I've posted over at their list ( https://groups.google.com/forum/#!topic/linux-sunxi/nIHO4PoY0ZQ). So far no reply. According to the old instructions you have to specify --with-cards=emu10k1