]on Behalf Of Johan Grip
Sent: 18 February 2010 15:21
To: cisco-nsp@puck.nether.net
Subject: Re: [c-nsp] Renumbering serial interfaces
On Thu, 18 Feb 2010 14:22:26 +0100, Steve Bertrand
st...@ibctech.ca
wrote:
On 2010.02.18 03:22, Brian Turnbow wrote:
Besides the reload in xx
Isn't configuration rollback supposed to bypass the reload in 5 issue?
--
Tassos
Gert Doering wrote on 17/02/2010 22:30:
Always remember to put in reload in 5 before you do anything that might
lock you out, and reload cancel afterwards...
gert
: mercoledì 17 febbraio 2010 19.20
To: cisco-nsp@puck.nether.net
Subject: [c-nsp] Renumbering serial interfaces
I have a bunch of T-1 (ATM) interfaces that I need to renumber. I have
always done this with 2 people, one on each end. Is it possible for one
person to do this, from one end ?
If I am
I have a bunch of T-1 (ATM) interfaces that I need to renumber. I have
always done this with 2 people, one on each end. Is it possible for one
person to do this, from one end ?
If I am on the near side, I log into the far sides serial IP and do this:
You could setup ipv6 between the two
-
From: Steve Bertrand [mailto:st...@ibctech.ca]
Sent: giovedì 18 febbraio 2010 14.22
To: Brian Turnbow
Cc: james edwards; cisco-nsp@puck.nether.net
Subject: Re: [c-nsp] Renumbering serial interfaces
On 2010.02.18 03:22, Brian Turnbow wrote:
Besides the reload in xx that several have mentioned you
On Thu, 18 Feb 2010 14:22:26 +0100, Steve Bertrand st...@ibctech.ca
wrote:
On 2010.02.18 03:22, Brian Turnbow wrote:
Besides the reload in xx that several have mentioned you can also put
secondary Ips on the link
Nad then cancel the primary.
I.e.
interface ATM0/0.32 point-to-point
Ip add
Hi,
On Thu, Feb 18, 2010 at 08:58:56AM -0500, Steve Bertrand wrote:
I suppose that considering that this is a PtP link, the OP could apply
an IPv6 address to each end, verify reachability, and temporarily remove
all v4 addresses and still maintain a connection until the work is
complete :)
...@puck.nether.net] On Behalf Of james edwards
Sent: Wednesday, February 17, 2010 1:20 PM
To: cisco-nsp@puck.nether.net
Subject: [c-nsp] Renumbering serial interfaces
I have a bunch of T-1 (ATM) interfaces that I need to renumber. I have
always done this with 2 people, one on each end. Is it possible for one
person
You can renumber serial links with one person. Standard disclaimer of paying
attention to detail, being careful, etc.
If you can tolerate a few minutes downtime worst-case (which, I'm making the
assumption this is being done in a window that can), you can also use the
'reload in x' command, where
Hi,
On Wed, Feb 17, 2010 at 11:19:31AM -0700, james edwards wrote:
I have a bunch of T-1 (ATM) interfaces that I need to renumber. I have
always done this with 2 people, one on each end. Is it possible for one
person to do this, from one end ?
If I am on the near side, I log into the far
10 matches
Mail list logo
