Stus-List C&C 32 Genoa sheets

I am about to purchase new sheets for my 135% Genoa to be compatible with my new St 40 Primary winches and measured my old sheets up at a total of 94 Ft. Seems a bit excessive. Some rough estimates get me to 84 Ft total. Any sources and experience for the recommended length of sheets for a 135% on

Re: Stus-List C&C 32 Genoa sheets

the genoa sheets. Rick Taillieu Nemesis '75 C&C 25 #371 Shearwater Yacht Club Halifax, NS. From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of John Russo via CnC-List Sent: June-18-14 14:58 To: CnC-List@cnc-list.com Subject: Stus-List C&C 32 Geno

Re: Stus-List C&C 32 Genoa sheets

60’ of ½” double braid for the genoa sheets. Rick Taillieu Nemesis '75 C&C 25 #371 Shearwater Yacht Club Halifax, NS. From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of John Russo via CnC-List Sent: June-18-14 14:58 To: CnC-List@cnc-list.com Subject

Re: Stus-List remove head sink on c n c 32?

I would try removing the door to the vanity and the door to the head to allow alternate access angles and plenty of padding as has been suggested. I have approached this lying on my side. John Arpeggio From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of David Jacobs via CnC-Lis

Re: Stus-List Re-Bedding / Filling & Drilling w_Epoxy

Just a note - My experience is to tape the hole below deck and pour in a small amount of thickened epoxy which does not drip past the tape to form a new epoxy seal or bottom layer when cured and then wet the cored out area and then fill with thickened epoxy. John Arpeggio C&C 32 Norwalk, CT

Stus-List Vodka for Hot water tank

Any downside to putting some vodka in the hot water tank after draining as an alternative to antifreeze which forever smells when using hot water. The drain in not quite positioned at the bottom of the tank so there is always some residual water left in the tank and although I leave the drain valve

Re: Stus-List Vodka for Hot water tank

Thanks for all the advice re Vodka and Hot Water tank. I have decided to simply drain the tank and leave all valves open for expansion and not do Vodka. John From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of John Russo via CnC-List Sent: Monday, October 26, 2015 8:21 PM

Re: Stus-List Vodka for Hot water tank

s on the elements. The 3-way valve I suggested also ensures that a flush path is available for that sediment. Many designs have the drain "T"ed off of the cold water inlet port so flushing really doesn't pass water through the heater at all. Josh On Oct 27, 2015 6:36 PM, "

Re: Stus-List Hydrolocked!

My experience with hydro lock is to avoid it by putting the bucket in the locker below the cockpit and at engine level so excess water is not forced due to gravity into the engine when the pump is not operating. John Russo Arpeggio C&C 32 Norwalk,CT From: CnC-List [mailto:cnc-list-boun.

Re: Stus-List Changing oil filter Yanmar 3gmf

I have a 2GMF and use a small foil baking tin below the filter that can be bent to shape around engine parts and drop the entire filter with oil into the tin. Gets most of the oil and then just wipe up any spill with a blue paper shop towel. John Arpeggio -Original Message- From: CnC-Li

Re: Stus-List Boom vanging...

I would second the Garhauer experience. They can recommend size and build flange fit to your mast and great to work with. Try catching them at a boat show or during a show for best price. John Russo Arpeggio C&C32 1984 Norwalk, CT From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On

Stus-List Soft shackle

Is anyone using a soft shackle to attach the Jib clew to the sheet? If so what brand and any problems in operation like catching on shrouds. John Arpeggio 1984 C&C 32 NorwalkCT ___ Email address: CnC-List@cnc-list.com To change your list prefere

Re: Stus-List Soft shackle

10:05 AM, John Russo via CnC-List wrote: Is anyone using a soft shackle to attach the Jib clew to the sheet? If so what brand and any problems in operation like catching on shrouds. John Arpeggio 1984 C&C 32 NorwalkCT ___ Email address:

Re: Stus-List radar mast/pole on C&C 32

Hans, Take a look at Arpeggio1984.info web site under 2007 projects. Only on pic there showing where to locate on port just forward of stern cleat and adjacent aft pulpit for support. All Edson hardware. John Arpeggio C&C 32 1984 From: CnC-List [mailto:cnc-list-boun...@cnc-

Re: Stus-List Antifreeze Mystery

Check to insure your engine block drain valves are tight before winter storage. Second thought is weird but offered anyhow. Is antifreeze fresh? Could there be a blockage somewhere where the antifreeze is diluted and freezes which would expand and force the top stuff out somehow. I said it was a we

Re: Stus-List Grey Potable water connectors

The fittings shown in the picture are definitely Quest and they are still manufactured and available. I just had to redo my Raritan hot water tank connections in a new tank install and had no problem getting them through the marina work shop and a local marine store.( not carried by West Marine) I

Re: Stus-List This is very cool...

Thanks Nathan – See you on the 23rd - John From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Marek Dziedzic via CnC-List Sent: Thursday, June 11, 2015 11:48 PM To: cnc-list@cnc-list.com Cc: Marek Dziedzic Subject: Re: Stus-List This is very cool... Also this one: http:

Stus-List 12 volt cordless drill

I am looking for a small light duty light weight 3/8 max bit size, 12 volt cordless drill that has a 110 volt charger and also has a 12 volt cord with cigarette lighter adaptor that can be used directly connected to the house batteries. Does anyone have any recommendations? John Arpeggi

Stus-List Thanks - 12Volt cordless drill

Thanks everyone for the responses re the 12 volt Cordless drill. I do have a 18 volt Black and Decker that has served me well over the past 10 years but don't leave it on board after commissioning each spring. I do have an old manual drill on board and I will probably stick with that to save space

Stus-List Universal 40

A friend just purchased a 1984 Bristol 38 with a Universal 40 engine and wondered if anyone could provide a wiring diagram for the engine and electrical control panel etc that he can use as a starter diagram to help trace out his wiring. I have been following the recent discussions re glow plugs et

Re: Stus-List Off topic-Newport boat show 2015

There is a parking lot for the show and shuttle from the parking lot in Newport at the beach just past the show. If I remember correctly it is $15 for the day including shuttle. John Arpeggio 32 Norwalk. CT -Original Message- From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On

Re: Stus-List Engine Sound Insulation - Go Without?

Robert, If you ever do decide to install new insulation I can share a few tricks to make it easier as I re-insulated the compartment in my C&C 32 last year. I used material purchased from Defender which is reflective containing foam and rubber and lead which is impossible to drill holes i

Re: Stus-List Broken Goose neck

Garhauer Marine fabricated a stainless goose neck for my 32 to work with a solid vang. Very reasonable. Ask for Guido or Marc and send them your broken goose neck for dimensions and mast shape. John Arpeggio C&C 32 Norwalk CT From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Be

Stus-List My sailing stuff on EBay

Just a heads up that I have listed the following on Ebay 110 ft 3/8 Sta Set X New England low stretch Spinnaker Halyard Red flec - Very good condition - Lightly used - (2) - 46ft matched lengths of 7/16 New England Rope Sta Set double braided Polyester Jib Sheets - Blue Flec- Moderate u

Stus-List Ebay Marine items listing

I have listed the following items on Ebay and they can be found by entering the following numbers in the search inquiry: 141539737045 - Automac Alternator output controller with 50 Amp Ammeter - Condition New - 141542728811 - Jib Sheet 92 Ft 9/16 Sta Set New England Ropes - Good Condit

Re: Stus-List Diagram for deck arrangement on C&C 32?

Hans- Eric, Welcome to the CnC group and congratulations on your new ownership of a great boat. Take a look at Arpeggio1984.info which shows a number of upgrades including deck layout and rigging that I have made since 2005 when I purchased the boat. Look under Projects from years 2011 through 201

Re: Stus-List C&C 32 Mainsheet Traveler Location

I agree with Neil, I however use two ends of the same line back to the helm. I have Harken long throw jam cleats on the cabin top that allows me to snap the line loose like flicking a whip or jam it by pulling down. See arpeggio1984.info web site, under projects. I can look up the jam cleats if

Re: Stus-List C&C 32 Mainsheet Traveler Location

or iOS <https://aka.ms/o0ukef> On Sat, Jul 2, 2016 at 9:35 PM -0400, "John Russo via CnC-List" wrote: I agree with Neil, I however use two ends of the same line back to the helm. I have Harken long throw jam cleats on the cabin top that allows me to snap the line loose like

Re: Stus-List C&C 33 Rudder Post lubrication

Dave, If the Cup is salvageable and threads are intact you can have a new cap fabricated to same dimensions with threads and have a grease fitting screwed into the cap and then screw it down to the cup and use a small grease gun thereafter without ever having to unscrew the cap again. This assumes

Re: Stus-List repacking toerails

Check out Butyl tape on Google and look for Grainger. I saw 2” wide x 1/8 thick by 30Ft for about $14. I have a C&C 32 so 3 rolls can do the entire boat. John C&C 32 Arpeggio Norwalk CT From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Tim Sippel via CnC-List Sen

Re: Stus-List repacking toerails

https://www.grainger.com/product/4PDE9

Stus-List Flag lines on C&C 32

Does anyone know the length of the flag lines on a C&C 32. I am away from the boat and know that they should be replaced soon. Thanks in advance. John Russo Arpeggio C&C 32 1984 Norwalk, CT ___ This list is supported by the generous donation

Re: Stus-List Mast Boot Tape

Try using the sail stop fixed above the cover if you cover the boat and stuff some putty type material at an angle above the sail stop to catch and pitch water out of the slot. John Russo Arpeggio C&C 32 1984 Norwalk, CT From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of N

Re: Stus-List Engine compartment insulation?

Bruce, I did this on my 1984 C&C 32 and the results are great using 1” thick with reflective surface and foam and actually a Rubber intermediate layer. I purchased the material from Defender and would recommend the kit or components of the kit for the most straight forward approach. I did no

Re: Stus-List New potential C&C owner... maybe?

Not familiar with the boat but beautiful lines and looks clean. I have a 1984 C&C 32 and love it! I know this does not necessarily help but you will not be disappointed assuming the boat is in as good shape as she looks. John Arpeggio C&C 32 1984 Norwalk CT USA From: CnC-List [mai

Re: Stus-List Ye Olde Stuck Seacock issue

I am the 2nd owner of a 1984 C&C 32 and have sailed her for 14 yrs and never had reason to close the cockpit drains and as mine were stuck when purchased I assume the previous owner never closed them. Make sure the hose and connections are good and forget it. I would be more concerned with