Allen C. Ward wrote:
Several times I have found small parts clinging to the paper debris
after they came up missing.
So true...one small inhibiting factor acting against me starting K2 1641
(for five years!) was that one resistor pack came up missing during the
initial inventory. While
We are getting a lot of requests for the parts to make G3RXQ's K2 Pre
Filter. To facilitate this, we have made a build list with all the
parts that we can supply for a nominal charge. The list is based on the
description and schematic found on G3RXQ's website. Included are the
crystals,
Hi all!
I´m right now getting near the end of my K1-project. Receiver works like
a dream, but I think I´m getting mad when I´m trying to get ANY power
out from the transmitter. The output meter shows P 0.1 and my WM-2
wattmeter shows 0.000 mW
I started to suspect that something was
Sounds like you might have a bad hetrodyne crystal on 40 meters. If you
have a general coverage receiver tune it to the oscillator frequency and see
if you hear a strong carrier when you move the antenna near the crystals on
the filter board. If not you may have a bad crystal or a bad solder
~~
N2CQ QRP CONTEST CALENDAR
March 17-31, 2005
~~
40 METER FOXHUNT - Each Friday, 0200z to 0359z
(Thurs 9 PM to 11 PM EST) (Ends Mar 18, 0359z)
Info:
Thank you for the responses and I'm pleased to get some discussion going on
this subject on the reflector. Phase noise has been brought up before, but
not discussed in detail. As I said I've had personal emails about this so I
know I'm not on my own here.
I should point out that my comments
Hello boys!
I am playing around same problem for last two weeks.
I had written to reflector but no one was interested to comment.
I am using K2 for HF contesting with LL PA and for VHF contesting with
transverter+ LL PA and i also want to have signal clean as much as possible.
I was testing K2 on
7 matches
Mail list logo
