In addition to my previous post…
If ATU-Mod is saved per Antenna, then one could switch, and compare instantly
the results, eg. antenna 1 with or without internal tuner, and antenna 2
directly connected or with external tuner, on the same band.
73, Gerald - HB9CEY
Hello All
My activ setup here
Hello All
My activ setup here consists of a KX3/KXPA100 with ATU and 2 antennas.
Antenna 1 is a dipole fed with balun into twinlead and matched with the ATU,
mainly used for the 6 - 30m band.
Antenna 2 is a vertical (H-loop) with an SGC-Tuner at the base of the vertical,
used mainly for 40 and
Hello All
In preparation of this contest weekend I have noticed that the additional
function in the cw wght menu , tap 2, is not yet available. The '@' character
can't be chosen to stop cw transmitting. This makes software like RUMped
unusable for cw activity with the KX3 as the '@' is just
Hello Don
Many thanks for the quick response and precise directions where to look for.
Yes, RP2 is 10k and after removing both10k resistors all went well with CAL PLL.
I had overlooked the note about the 100k RP2. My fault!
Again, your knowledge and help is great! Already thought that I have
Hello All
My K2 Rev. A worked all the years very well. But as I have the parts for
upgrading to Rev. B since long, I have now finally made the modifications,
except the Thermistor board installation, and run into problems with the PLL.
With CAL FCTR and BAND-, the reading is in range, but
I've built my KX1 #2203 a while ago and it was working well. After adding
30/80m there was low output from time to time which I found out had to do with
the LP-Filter-board.
So, these days I wanted to fix that and thereby caused some smoke, around Q6 I
guess. Probably tuned the TX to long to
Hello Don, thanks for your fast reply.
I meant a BD139 not BD136 of course, and I had mounted a small heatsink, but
maybe that was to small.
So I will take your advice and get the original type as a replacement of Q6 and
see how that works.
73, Gerald
7 matches
Mail list logo