hi everyone, would like to ask the group about a problem. I had no problem
with my K2 connecting with my N4PY software before a KAT/100 update from 1.09
to 1.10. ever since the update and service to the radio, I can not connnect
with my control software. Even with ham radio delux, it
I recently got my K2 serviced and updated. I was told by the technician that I
needed to tighten the mounting screws on Q1 and Q2 after 10 to 12 hours of use.
Failure to do so could destroy the transitors. I have read the KPA/100 manual
and it says to tighten these mounting screws after
Guys, I need some advise.I wrote last night about the keyer problem I had
with my K2. That has been resolved. Now I have a new problem that surfaced
late last night. I was using the automatic antenna tuner and on 20 meters and
it seemed it was laboring tryin to tune. It tuned alright.
HZ
Ø SSB filters provide programmable low and high cutoff frequencies.
Ø Four levels of noise reduction are available in cw and ssb
Ø SSB mode includes automatic notch filter.
Ø KIO2 aux I/O module for computer control
John Klokis K3JK will discuss price thru email. Lets
John K3JK here, Would someone give me some feedback on my K2? I plugged a
mono plug into my keyer jack when I was using an external keyer. I might have
shorted a resistor or diode. now as soon as i plug the keyer in with a stereo
plug, i get a constant carrier. When I had the mono plug
Good afternoon
this is John Klokis, kb3hqh. I recently became a proud owner of a
Elecraft K2 with 100 watt option and automatic antenna tuner. I would like to
ask you for some help in getting the right computer cable to run the setup I
have with my computer. I do not need to run
first of all I want to thank everyone for replying to my question. I should
have told you how I hooked it up. I have the regular k2 cable that interfaces
with the antenna tuner, then goes into a long cable with the serial connector.
so it has three serial connectors.
I plugged a radio shack
7 matches
Mail list logo