Thanks, working great now.
Regards,
Mark, K1RX
On Friday, February 22, 2019, 9:25:28 AM EST, hawley, charles j jr
wrote:
45
Chuck Hawley
c-haw...@illinois.edu
Amateur Radio, KE9UW
aka Jack, BMW Motorcycles
From: elecraft-boun...@mailman.qth.net on
behalf of Mark Pride
When I setup a command (via N1MM) to turn on/off the RX antenna selection, it
was identified as SWT 25, what is the SWT # for the RIT? Want to toggle the
RIT on/off in the same way, via a function key.
Regards,
Mark, K1RX
Hello all,
Ran into some issues with the K3 after adding some new boards. Here is the
sequence of screens on the radio as I move to get it going again.
Few more experiences - And added some more notes in the first email below.
On SSB, it transmits okay, no ERR on screen. When I just send a
Recently noticed a problem with receive audio. Hear a crackling sound while
using the headphones and that noise does NOT vary as a function of the AF gain
control. It comes and goes, very random and very objectionable. Almost like
hearing instability in the audio stage of an old vacuum tube
Thanks to all that helped. Final answer was the filter setting was wrong. Was
trying use the CW filter on SSB (that's why only a narrow audio frequency range
seemed to pass) - set filters properly and all is good.
Manual fix or the utility software handled this fix.
Regards,
Mark, K1RX
connections - no change
With or without ATU on - no change
Different mics tried and no change.
Swapped power supplies (one K3 to the other) no change
Suggestions now?
Regards,
Mark, K1RX
On Monday, February 24, 2014 11:03 PM, Mark Pride mpride...@yahoo.com wrote:
Yes did the cal and worked
Just installed the KPA3 module, went from 10 watts to 100 watts - good.
On CW, full power out, no problem.
On SSB, initial voice peak drives power out to the max (100 w) but within
moments, the power drops way down to say, 10 or 15 watts, then randomly spikes
back up but not as a function of
Anyone here have experience wiring up the MFJ-434B Digital Voice Keyer to a K3?
At one time I had learned the K3 mic plug was the same as Kenwood.
Regards,
Mark, K1RX
__
Elecraft mailing list
Home:
First time having an issue with my K3 - have the 100 watt module and today, got
an error on the display indicating ERR12V and the power dropped. Had to adjust
upward to only reach 12 watts.
Need some guidance from the group - I hope the 100 watt module is not blown.
Please advise and
-
From: John jmcbe...@km5ps.com
To: Mark Pride mpride...@yahoo.com
Sent: Friday, January 4, 2013 8:23 PM
Subject: Re: [Elecraft] K3 power drop and ERR 12V
On 1/4/2013 6:14 AM, Mark Pride wrote:
First time having an issue with my K3 - have the 100 watt module and today,
got an error
10 matches
Mail list logo
