[Elecraft] K3 External Reference input

Is there interest among the group for the necessary parts to input a disciplined 10MHz signal to control frequency? We all know there is a place holder on the back panel, but Gary just told me there were no plans. In April Wayne said it was coming but the price hadn't been set. Just wondering if

RE: [Elecraft] K3 External Reference input

Spectracom. 73, Phil K3(352)TUF -Original Message- From: Paul Christensen [mailto:[EMAIL PROTECTED] Sent: Friday, February 22, 2008 8:24 PM To: Philip Theis; elecraft@mailman.qth.net Subject: Re: [Elecraft] K3 External Reference input Is there interest among the group for the necessary

RE: [Elecraft] K3 Transverter

Greg, You hit the nail on the head. Thanks, Phil -Original Message- From: Greg [mailto:[EMAIL PROTECTED] Sent: Friday, February 08, 2008 11:14 PM To: Philip Theis; elecraft@mailman.qth.net Subject: RE: [Elecraft] K3 Transverter Hi Phil, I'm not a transverter user, but seems like you

[Elecraft] K3 Transverter

I am unable to get the XVTR port to work on receive (haven't gotten to transmit yet) I have the menu items set up for transverter use, and I can get input to the radio just fine into the antenna or the RX IN port, but nothing on the XVTR IN port. I'm sure it's a setup issue, any thoughts? Thanks

[Elecraft] K2 FS

K3's on it's way so it's time to sell my K2. This is SN 1309 and has been used in many successful VHF/UHF contests. Consists of: K2 KSB2 K160RX K60XV KNB2 KDSP2 KAT2 KIO2 KBT2 Email off list to discuss. Thanks, Phil K3TUF ___ Elecraft mailing list Post

[Elecraft] FS: K2 Complete

Making way for K3 Available: K2 1309 w/firmware upgrade KSB2 K160RX KNB2 KDSP2 KAF2 (still a kit) KIO2 KAT2 KBT2 Additional Cover KRC2 DEMI Transverter interface module All working fine, check 2007 January VHF Contest Results. New unbuilt cost total is over 1600 Offering everything for 1200 to

[Elecraft] IF feed for spectrum display

Eric put out a discussion of using an extra high impedance input buffer stage taking its signal from the output of the 2N5109 to properly isolate the external IF device. Does anyone have a simple circuit already worked out for this? If so, will they share it? I was contemplating a 2N5179 but

[Elecraft] CAL FIL question

Don, I just upgraded my firmware from 2.01 to 2.04 (along with the accompanying io upgrade) on my K2 sn 1309. I didn't do a good job of saving my settings, so I'm out of cal. I've gone through all possible (I think) kinds of calibration methods. What is the correct method? My main concern is SSB.

[Elecraft] KAF2 K2 Audio Filter and RTC for sale

Hi, I have an un-built KAF2 for sale. Please make offer via email, Thanks, Phil ___ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.):