Re: [Elecraft] K3 Line Out audio input to Remote Rig RRC 1258 MKII

Thank you Barry for the great suggestion. VO1HP -- Sent from: http://elecraft.365791.n2.nabble.com/ __ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post:

[Elecraft] K3 Line Out audio input to Remote Rig RRC 1258 MKII

I have a Remote K3 using K3 Mini at my home shack. The audio output from the remote K3 is taken from the SPKRS jack and fed to the Audio IN jack on the RR box. I have often wondered about taking audio from the LINE OUT jack and feed that audio to the RR Box. Doing this would allow me to use

[Elecraft] KPA500 Remote Software will not pin to STARTUP list

After a failed attempt to operate my remote KPA500 using a STARTECH serial server I have reverted back to a PC at the site. To streamline operations I want the KPA remote software to start up when the PC is remotely booted. Right clicking and selecting Pin to Start does not work. It does not

[Elecraft] Wanted: Elecraft cable KXSER

Anyone have a KXSER cable surplus to their needs? Need for use with KAT500 and Ethernet - Serial device server. Frank VO1HP -- Sent from: http://elecraft.365791.n2.nabble.com/ __ Elecraft mailing list Home:

Re: [Elecraft] TCP Port for KPA500 and KAT500

Jack The interface is a StarTech NETRS2322P two port Ethernet to Serial Port server which will eventually go at my remote to replace the PC there that currently runs the Host software for the KPA and KAT. TCP Port forwarding must be done in both routers to open the full duplex path between

[Elecraft] TCP Port for KPA500 and KAT500

This may be a dumb question but here goes In the Elecraft remote software for the KPA500 and the KAT500 the TCP port for the KPA500 is 4626 and 4627 for the KAT500. Are these ports somehow "hard coded" in the communications software for the two units?...OR can one assign any port. I am

Re: [Elecraft] KPA500 MCU LOAD screen

Andy Yes I have a StarTech Ethernet to Serial port server attached to the RS232 jack. I have been trying to get it to work with the amp so that I can get rid of the PC at my remote. Thanks for the solution. Maybe there is something wrong with the server if data possibly corrupted . Have not

[Elecraft] KPA500 MCU LOAD screen

I came in the shack yesterday and the KPA500 screen was lit with MCU LOAD message. I did not leave the amp on. The amp was on when I arrived. I updated the firmware to the current release. This morning the same thing happened. When MCU Load message is on the screen none of the front panel

Re: [Elecraft] Running KPA500 and KAT500 Remotely Without K3

Mitch Did you receive any answers to your question in this post. I currently control my KPA500 KAT500 combo using a Win 7 machine and the server in the Elecraft remote s/w. I connect to both from my control location using shack PC and the client side of the software. I want to eliminate the