Ben,
It sounds like re-heating of the solder connections on both sides of C121 is
in order. The fact that your RF voltage on terminal 3 of T1 has the proper
ratio to that on terminal 1 implies that T1's solder joints are OK. The
absence of RF on the driver (Q6 base circuit) side of C121 could
Ben,
When you have low output, it is normal for the RF voltages at the
working stages to be much greater than the listed expected values.
Since the Q5 output is higher than expected, but the Q6 input is zero
(or close to it), you have a problem between Q5 and Q6. Refer to the
schematic and
On Oct 28, 2012, at 5:51 AM, Mike K8CN mike.car...@unh.edu wrote:
It sounds like re-heating of the solder connections on both sides of C121 is
in order. The fact that your RF voltage on terminal 3 of T1 has the proper
ratio to that on terminal 1 implies that T1's solder joints are OK. The
I've had fun putting together K2 #7373, and am finally at the point of doing
the 40-Meter Transmitter Alignment (manual, p.78). I have the unit connected
to a 50-ohm dummy load, and am trying to tune L1 and L2 to show 2W on the
internal wattmeter. When I press TUNE, the measured power
Ben,
You are in for some Transmit Signal Tracing. Turn to appendix A in the
K2 manual and do the steps indicated there.
73,
Don W3FPR
On 10/27/2012 7:44 PM, Ben Byer wrote:
I've had fun putting together K2 #7373, and am finally at the point of doing
the 40-Meter Transmitter Alignment
, and a connection made, the
K2 was up and running.
73,
David
KC9EHQ
K2/10 #7164
From: Ben Byer bb...@mm.st
To: Elecraft@mailman.qth.net
Sent: Saturday, October 27, 2012 6:44 PM
Subject: [Elecraft] [K2] POWER control has no effect on actual transmit power
I've had
On Oct 27, 2012, at 6:23 PM, Don Wilhelm w3...@embarqmail.com wrote:
On 10/27/2012 7:44 PM, Ben Byer wrote:
I've had fun putting together K2 #7373, and am finally at the point of doing
the 40-Meter Transmitter Alignment (manual, p.78). I have the unit
connected to a 50-ohm dummy load,
7 matches
Mail list logo
