... Joe, W4TV
> -Original Message-
> From: Jack Brindle [mailto:jackbrin...@earthlink.net]
> Sent: Sunday, March 08, 2009 12:36 AM
> To: li...@subich.com
> Cc: d...@w3fpr.com; 'elecraft'
> Subject: Re: [Elecraft] [K3] Pull-up question
>
>
To add a bit more to Don's last point, there is a situation that few
folks (especially engineers) realize with respect to interconnect
drive systems. With todays low-power microcontrollers and digital
systems, it is very easy to accidentally power another device from the
driving device. In
on Wilhelm
>> Sent: Saturday, March 07, 2009 2:56 PM
>> To: Roger
>> Cc: elecraft
>> Subject: Re: [Elecraft] [K3] Pull-up question
>>
>>
>> Roger,
>>
>> That is where the situation gets 'sticky'. It all depends on
>> what the
&
h.net
> [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Don Wilhelm
> Sent: Saturday, March 07, 2009 2:56 PM
> To: Roger
> Cc: elecraft
> Subject: Re: [Elecraft] [K3] Pull-up question
>
>
> Roger,
>
> That is where the situation gets 'sticky'. It a
Roger,
That is where the situation gets 'sticky'. It all depends on what the
circuits at the end away from the K3 have implemented. You have two
pullup resistors on each line and 2 separate voltage sources.
1) If the voltage to the pullup resistors in the internal device do not
match the vol
> -Original Message-
> From: elecraft-boun...@mailman.qth.net
> [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Roger
> Sent: Saturday, March 07, 2009 12:04 PM
> To: elecraft
> Subject: Re: [Elecraft] [K3] Pull-up question
>
> Mike Fatchett,
> OK
ilman.qth.net] On Behalf Of Roger
Sent: Saturday, March 07, 2009 12:04 PM
To: elecraft
Subject: Re: [Elecraft] [K3] Pull-up question
Mike Fatchett,
OK, but what happens when you use them with devices
that already work without them,e.g. Array Solutions 6 Pack and early
Mike Fatchett,
OK, but what happens when you use them with devices that
already work without them,e.g. Array Solutions 6 Pack and early band decoders?
Roger K8RS
craft-boun...@mailman.qth.net
[mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Corboy-Poteet
Sent: Saturday, March 07, 2009 10:44 AM
To: elecraft@mailman.qth.net
Subject: [Elecraft] [K3] Pull-up Question
I've a question on the pull-up resistor mod for the KIO3 board: is this
addition being done to
I've a question on the pull-up resistor mod for the KIO3 board: is this
addition being done to support "legacy devices" or is it the wave-of-the-future
(or none of the above)? If current interface "standards" don't require the
pull-up capability and the outlook for the future is the same, I th
10 matches
Mail list logo