Hello All and Merry Xmas
Can't figure out where I went wrong here. Attached two 2-D fasteners
to one bare area and one
unbare area as per locations pictured on page 38. Yet when I went
to attach the sides to the RF
board, the only holes that fit are the bare ones, one of which I've
Jeff,
Yes, the long rectangular bare area (previously masked) will go at the
bottom. The other mouning holes may (or may not be) masked, but if masked
they will be short rectangular areas.
Remove the 2D connector from the bare area, then look at the diagrams
carefully.
The words in the
/100 #4941
-Original Message-
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of jrb
Sent: Thursday, December 15, 2005 7:08 PM
To: elecraft@mailman.qth.net
Subject: [Elecraft] Attaching sides to K2 RF board
Hello All and Merry Xmas
Can't figure out where I went wrong here
@mailman.qth.net
Subject: [Elecraft] Attaching sides to K2 RF board
Hello All and Merry Xmas
Can't figure out where I went wrong here. Attached two 2-D fasteners
to one bare area and one
unbare area as per locations pictured on page 38. Yet when I went
to attach the sides to the RF
board, the only
4 matches
Mail list logo
