I have built two K3's (the last one in March 09) and the calibration worked
fine
then.
As you say, there are work arounds but it would sure be nice if the K3
worked
as the manual shows.
Bob W6VY
This bug in the wattmeter calibration still exists in the latest firmware.
Pressing XMIT during
Hi Steve:
You're right. There is a disconnect between the manual and how the
firmware acts. There is a work-around, though. If you set up per the
instructions with the external wattmeter in line to a dummy load, set
power to precisely 5.0 watts for LP adjustment, go to CONFIG:WMTR, you
will se
This bug in the wattmeter calibration still exists in the latest firmware.
Pressing XMIT during the wattmeter calibration does not transmit, and
pressing TUNE does not permit a change of the calibration paramter. On the
other hand keying the rig via a keyer does allow the calibration to be
perform
Using the latest 2.80 firmware, I find a problem I didn't have with
prior versions. It may be unrelated to the firmware change. I have
only been using the radio for two weeks.
TECH MD set to ON and select CONFIG: WMTR LP or HP. The display shows a
three digit number. When I hold TUNE, the d
4 matches
Mail list logo