Here's follow-up on the power instability problem I have been
experiencing with one of my K3s:
Although I already had the latest firmware loaded in the K3, I
reloaded the firmware. I also ran the VCO MD calibration and
checked the 3 mounting screws on the bottom of the K3, as someone
had sug
I've mentioned this before, but several seemingly inexplicable problems I
have had with my K3 have been solved by simply doing a Parameter
Initialization (see manual.) Just be sure to save your configuration
first. May not help, but doesn't take long so always worth a try. One
caveat, that Don W
Something similar happened with my KX3. Support told me to reset and reload all
the firmware, and it worked fine after that.
I recommend that you get advice from Elecraft. Their advice worked for me.
wunder
K6WRU
On Mar 13, 2013, at 8:12 PM, Arliss wrote:
> Running the low and high power TX ga
Hi Arliss,
I recently had a similar problem with my K3. I contact Elecraft and received
this response from Gary:
-
See if it will produce 12w on 160-10m, and at least 8w on 6m, in Tune, with
the KPA3 menu set to Bypass. The VFO should be near the middle
Arliss,
If you do not have the latest firmware loaded along with the latest K3
Utility, please load the latest and try again. If it continues to fail,
contact k3supp...@elecraft.com.
73,
Don W3FPR
On 3/13/2013 11:12 PM, Arliss wrote:
Running the low and high power TX gain calibration via th
Running the low and high power TX gain calibration via the K3
Utility gave the following result:
"TX Gain calibration failed because power reading did not
converge to a consistent value. 5W calibration failed."
"TX Gain calibration failed because power reading did not
converge to a consiste
Arliss,
I would suggest that you run the Transmit Gain Calibration and see if
that improves the situation.
73,
Don W3FPR
On 3/13/2013 9:10 PM, Arliss wrote:
I'm experiencing a problem with instability in power output from my
K3/100. No word back from Elecraft yet (it's only been a few days)
I'm experiencing a problem with instability in power output from
my K3/100. No word back from Elecraft yet (it's only been a few
days), so I thought I'd try here.
The problem is that at relatively low power output levels
(approximately 10 to 40 watts), the power output does not remain
consta
8 matches
Mail list logo