Thanks, Ken, and others. That was it!
73,
Randy, KS4L
Ken K3IU wrote:
Randy:
In N1MM, go to the configurator, hardware tab, and click on the Set
button for your K3. Make sure that the "Radio PTT via command" is NOT
checked.
73, Ken K3IU
___
Elecr
Randy, it sounds like you have N1MM set up to activate PTT via serial
command to the radio. Look in your COM port config page for a checkbox where
you can turn off "Radio PTT via command".
GL & 73,
Carl, WS7L
K3 #486
> -Original Message-
> I enjoyed last weekend operating SSCW with my new
Randy, KS4L, wrote:
> However, the keying through N1MM operates as though PTT is enabled
> at the beginning of a transmission and disabled at the end. In other
> words, I hear no signals during the N1MM transmission. I'm keying
> through the RS232 port on the K3 from a standard serial port on
On Behalf Of Randy Moore
> Sent: Friday, November 07, 2008 9:13 AM
> To: elecraft@mailman.qth.net
> Subject: [Elecraft] K3 with N1MM question
>
>
> I enjoyed last weekend operating SSCW with my new K3/10 and
> N1MM. Both
> were a joy to use!! I have one curiosity howev
Randy:
In N1MM, go to the configurator, hardware tab, and click on the Set
button for your K3. Make sure that the "Radio PTT via command" is NOT
checked.
73, Ken K3IU
~~~
Randy Moore wrote:
I enjoyed last weekend operating SSCW with my new K3/10 and N1MM.
Both were a joy
Even if I go to QSK and/or set the delay to 0, I still hear the same
behavior - like the PTT is enabled throughout the transmission and no
signals are heard through the receiver. When sending with my paddles, I
hear normal QSK behavior. I must have some configuration parameter set
wrong in ei
I was running QSK with N1MM. I usually set the delay to 0. With
delay set to zero, I cannot tell a big differnce with QSK on or off
(on the K3) when using N1MM to key the rig.
David Wilburn
NM4M
http://www.nm4m.com
Randy Moore wrote:
I enjoyed last weekend operating SSCW with my new K3/10
I enjoyed last weekend operating SSCW with my new K3/10 and N1MM. Both
were a joy to use!! I have one curiosity however. I have the K3 setup
for semi-QSK with a delay of 0.03 which works fine for me at about 25
wpm. However, the keying through N1MM operates as though PTT is enabled
at the b
8 matches
Mail list logo