Adjusting the AGC threshold and slope on my K3 to my liking made all the
difference for me. I did the same on the KX3 and KX2, as well.
Tim
On Wed, Feb 17, 2021 at 11:21 AM Don Wilhelm wrote:
> Mike and Brett,
>
> Go to my webpage www.w3fpr.com and scroll the left column to the "Noisy
> K3"
Mike and Brett,
Go to my webpage www.w3fpr.com and scroll the left column to the "Noisy
K3" article for assistance in adjusting the AGC Threshold and slope.
73,
Don W3FPR
On 2/17/2021 1:57 PM, NJMike wrote:
Brett, I am new to the K3S. I set mine according to the Fred Cady book.
Mine are
Mike . . .
All rigs are "noisy" if you run the RF gain full bore.
Experiment with backing off the RF gain and increasing the AF gain (if
needed) until a good signal-to-noise ratio is attained by your ears.
This applies to both CW and SSB.
It will also be helpful if you put the AGC in
Brett, I am new to the K3S. I set mine according to the Fred Cady book.
Mine are slightly different from yours. But I don't have a good
understanding of how the settings affect the performance. Sometimes I think
the rig is very noisy, even when connected to a dummy load.
I am interested in
I'll admit I just don't know how best to adjust my K3S RK/SQL knob. I have
AGC-S on, filters wide open at 2.8, and have set:
AGC DCY nor
AGC HLD 0.00
AGC PLS nor
AGC SLP 012
AGC THR 008
AGC-F 120
AGC-S 020
On 14MHz CW Mode, where I see/hear CW no signal on my P3, with RF/SQL
rotated full
5 matches
Mail list logo
