Dave,
Yes, that is not good - you need a new 2N7000. Those FETs are quite
sensitive to static and likely became zapped at some point.
Send a note to Elecraft ([EMAIL PROTECTED]) and request a new one.
73,
Don W3FPR
David Wilburn wrote:
During the initial tests (from the right side of page 2
During the initial tests (from the right side of page 21 in the KPA100
manual) on U1 pin 3 -> ground, I measured just under 4k as opposed to
the > 10k.
I pulled out the schematic and checked pins 3 and 4 of the R-pack, and
they measured correctly. When I checked Q11, I read a bit over 100 ohm
2 matches
Mail list logo