Number 4 under OPERATION/TRANSMITTING on page 11, When driving the KPA500
with an Elecraft K3, use the K3's per-band power control to set the
amplifier output just below the desired peak output on each band.
That requires that you use the AUX to ACC cable between the K3 and the
KPA500 as shown
I recently finished up my KPA500 and it is a treat! I was astonished when my
first CQ call on 40m was answered by a station in Slovenia! No fancy antenna,
just a G5RV at about 50' running due N S, to get E/W lobes.
Only one thing I can't figure out and I haven't been able to find in the
Hi Bruce. Check CONFIG:PWR SET on the K3. I'm pretty sure that you need to
have it set PER BAND.
The KPA500 manual should say this, but I didn't see it in there when I
looked.
GL/enjoy
73, Carl WS7L
On Wed, Sep 4, 2013 at 7:32 PM, WILLIAM DAVIS bruceda...@me.com wrote:
However, for the
Yes, you will need to enter the CONFIG of your K3, and locate PWR SET. If it
is reading NOR, then you need to toggle it to read PER-BAND.
It has been so long since I added the KPA 500, and made those settings, I
really can't recall if there are additional steps to follow. I am sure more
help
4 matches
Mail list logo