Hello Peter!
During the lowpower wattmeter calibration we appear to have no TX output.
Test indicate no RX either.
Please direct K3 support questions to "[EMAIL PROTECTED]" rather
than the reflector.
Sounds like you may not have the filter enabled, or perhaps one of the
cables between th
Make sure the bit jumper block is in (connects the PA's power). Also,
make sure your filter(s) are set up properly. Make sure the filter
you want to use for transmit is enabled, etc.
matt - WA6EGJ
k3 # 24
On Sat, 15 Dec 2007 20:16:32 +1300, you wrote:
>Good afternoon/evening fromZL
>
>We have
Good afternoon/evening fromZL
We have assembled the k3 and run the initial test stages and have run into a
problem.
During the lowpower wattmeter calibration we appear to have no TX output.
Test indicate no RX either.
Yes we have upgraded to the latest firmware, 01.49
Any suggestions???
Pe
3 matches
Mail list logo