switch to the USB position after completing the
firmware upload.
73, Ron AC7AC
-Original Message-
From: Elecraft [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Mike
Murray
Sent: Sunday, September 11, 2016 10:16 AM
To: Rick Bates (WA6NHC); elecraft@mailman.qth.net
Subject: Re: [Elecra
Once again, thanks to everyone on the list for input. I was finally
successful in getting everything reloaded only after disconnecting
everything but the serial cable to the PC. Thanks to Don and Bill for
pointing that step out as a solution. Thanks also to Dick for pointing out
the help files
There is a fairly detailed procedure in K3 Utility Help, Troubleshooting,
MCU Boot Loader.
73 de Dick, K6KR
-Original Message-
From: Elecraft [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Mike
Murray
Sent: Sunday, September 11, 2016 08:52
To: Elecraft@mailman.qth.net
Subject:
Do you have a P-3? If so, you might need to reconnect the RS232 directly to the
K-3 rather than the P-3 before starting the process.
Jimmy Walker
WA4ILO
Macon, GA
> On Sep 11, 2016, at 1:15 PM, Mike Murray wrote:
>
> Thanks for the suggestions so far - tried each several
Mike,
Remove the K3 power cord and wait at least 2 minutes.
While waiting, reboot the computer and after it comes up, power on the K3.
Check to see if K3 Utility can find the K3.
Try the Force Firmware Download again.
If that still does not work, disconnect everything except the RS-232
cable
Thanks for the suggestions so far - tried each several times but the K3 is
still toast.
On Sun, Sep 11, 2016 at 10:59 AM, Rick Bates (WA6NHC)
wrote:
> Try a full power off shutdown of the computer. If a desktop, pull the
> power cord for 30 seconds to completely discharge
I have the same problem with my K-3 from time to time. It’s a major
inconvenience but it’s not fatal. I’ve tried a couple of times to get help from
this forum but no one seems to have a good answer. My best theory is that there
is a defect with the firmware chip. It’s not a widespread defect,
Have you removed power, waited 2 minutes, then restored power?
Sent from my iPad
> On Sep 11, 2016, at 11:52 AM, Mike Murray wrote:
>
> I was in the process of updating my K3's firmware this morning when
> something apparently burped leaving the K3 bricked. The radio is
8 matches
Mail list logo