Hi Folks,
I have for sale my K2, SN504 with 2.03D/1.07 firmware. Nicely built and in
great shape. I'll supply pictures as needed.
K2 with:
KSB2
K160RX
KNB2
KAF2
Would like to get $600.
Thanks,
Steve
kc7zvm
_
Interest Rates
I have built more than 170 K2's. Let me build your radio. My prices are
reasonable and you end up with a finished radio ready to play.
73
Alan
W1HYV
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the
I have my K2 built to the second alignment step. It passed all the tests
on the first part of the build on initial power up. My K2 is not hearing
the 7. birdie. I am not hearing anything on 40 meters from receive
signals with an outside antenna connected or my broad band generator
Glenn,
Whoa!!! One thing at a time and first things first.
First, the VFO voltages. The slug on L30 should normally tune near the
top - about 2 to 3 turns from the top is normal. If that is not true,
first check the number of turns on T5 - count only the turns that pass
through the center of
20M: Heard N0SS at the start of the net but Tom faded in
mid-transmission. W3MC was 10 over 9, and did the QNP. Heard no one else.
40M: Kevin at about audibility but not really readable due to QSB. Tom
was 579 when I checked in and 15 over when I headed for the shower,
probably what
Respecting the placement of the solder lug on the
antenna connector J2, is the lug really supposed to be
installed on the screw nearest the top edge of the
rear panel? Seems if its installed there it's going
to come close to interfering with the with the circuit
board to which the rear panel
I found my problem. I left C158 out some how. I now have signal and the
7. birdie.I am able to peak L1 and L2 without the slugs bottomed out
in the cans.
I do have a concern The highest I can get L30 to adjust to is 5.5 volts
with the slug in L30 all the way to the bottom of the can. I am
7 matches
Mail list logo
