Mike Lichtman wrote
When using the auto notch, I find a diminished volume. Anyone else
noticing this? 73 Mike KF6KXG
Yes, the same here! When auto notch on, regardless of whether beat
cancelling or not, I have to increase the audio gain by about 10 steps to
get the same audio level (using
Hans,
Addressing the distortion only - if one places a notch in the audio
response, that will create distortion. How bad it is will depend on the
frequency of the notch, its width and depth.
73,
Don W3FPR
On 5/18/2015 10:56 AM, dk9nl wrote:
And the SSB signal sounds a little bit distorted
Removed all batteries then replaced and the radio came back (FW rev 01.87).
Tried connecting again, it seemed to work and tried to update the firmware
but failed. Here are the logs;
Elecraft KX3 Utility for OS X Revision 1.14.4.11
KX3 MCU revision --. RS232 speed 38400 bit/s.
Starting MCU
I finally got to do the Extended Temp Compensation on my KX3 over the
weekend. While we were doing this we used the utility to view ADC/freq
values. Unfortunately, I made the assumption these were being saved to
a log file. If this was the case I can't find the log file!
So my questions
Eric...that's the most ridiculous thing I've read today. How is it the
KX3 owners fault at all? Please, explain.
On 5/18/2015 1:06 PM, EricJ wrote:
If someone steals your radio, the thief is only partially to blame.
Eric
KE6US
But to make it worthwhile, you’d have to increase the mass of the frame (there
isn’t one at present) and stop the screws on the panel being undone.
73 de David, M0XDF (K3 #174, P3 #108)
--
Man is the best computer we can put aboard a spacecraft and the only one
that can be mass produced with
I don't know the details in this particular case. I googled KX3 stolen
and got two hits. One was stolen at Dayton...no doubt a target rich
collection of rigs to steal what with half the cars bristling with
antennas. The other was stolen in 2014, locked in the trunk of a car at
night with a
Was just browsing thru the KX3 manual and happened upon a section that says
a KX3 can (maybe, someday?) be used to control a remote KX3 via the
internet. That's exactly what I would be looking for but cannot find
anything further. Anyone have any info on this or similar possibilities
for
Ted, it's all of the above...and then some!
Part of what makes Elecraft so great is that Wayne, Eric, and the rest of
the team go to extraordinary lengths to make sure Elecraft owners have the
best possible experience, from unpacking the components to on-air
experience.
Ian, KM4IK
On May 18,
Greeting all,
I've got the correct S/N from Elecraft this afternoon. It is S/N 6168. There
has been a lot of chatter about this incident, and my intent was not create
a very long thread. Here is what happened:
1. The radio was in a small fabric bag in the trunk with other things. I
don't believe
Once you rule out the impossible, then all things are possible...it is quite
probable that a Ham operator stole the KX3. As others have already noted,
sometimes very good people become so tempted that they cannot contain their
desire and the result is thievery. Sadly, in this modern age of
11 matches
Mail list logo