Hi,
I have got to the VCO alignment stage of aligning my K2.
I have got 7.4 volts on R30, this does not change when turning the core in L30.
The core moves but does not appear to move up or down so I suspect that the
VCO inductor is damaged.
Does anyone know where I can get a replacement?
Sorry, made a mistake and used the wrong frequency while attempting to set up
the VXO.
Now the voltage at R30 is 4.3volts and does not change when adjusting L30.
Previous post
‘ I have got to the VCO alignment stage of aligning my K2.
I have got 7.4 volts on R30, this does not change when
message:
From: Allan Forster
Date: 25 September 2023 at 14:21:18 BST
To: elecraft@mailman.qth.net
Subject: [Elecraft] Elecraft K2 serial number 7699
Sorry, made a mistake and used the wrong frequency while attempting to set up
the VXO.
Now the voltage at R30 is 4.3volts and does not change when
Hi,
Thanks to everyone that sent suggestions regarding my broken K2/10.
I tried all suggestions but still broken, I did find that the frequency probe
was broken though.
The probe is now fixed and have been able to go through the alignment steps
from the manual.
I got as far as the VCO
Hi,
I found that the actual power out did not match my setting, eg. I set 10 watts
but power meter reads 14 Watts.
Simple to calibrate the auto ATU or so I thought. While adjusting the 2 pots on
the ATU the rig suddenly powered down. When I switched it back on the RX was
not working, I
Hi,
I have recently acquired an Elecraft K2/10, it is an early model, serial Nr.
00739.
I am looking for a manual specific to that early model or at least the
re-alignment instructions.
The transceiver is in very good condition but appears a little deaf.
I have the following options fitted.
SSB
6 matches
Mail list logo